{"product_id":"dance-floor-adhesive-latex","title":"Rosco Marley Floor Adhesive","description":"\u003cp\u003eA commercial-grade latex adhesive for permanently bonding marley and sheet-vinyl dance flooring to an approved interior substrate. This aggressive, pressure-sensitive formula is built for glue-down installations where the floor needs to stay put under heavy studio use. It is Green Label Plus Certified and contributes to LEED low-emitting materials credits, with a low-odor profile that makes it suitable for use in occupied buildings.\u003c\/p\u003e\n\n\u003ch3\u003eKey Benefits\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eGreen Label Plus Certified\u003c\/li\u003e\n\u003cli\u003eContributes to LEED (low-emitting materials)\u003c\/li\u003e\n\u003cli\u003eUp to 2 hours of working time\u003c\/li\u003e\n\u003cli\u003eLow-odor formula suitable for use in occupied buildings\u003c\/li\u003e\n\u003cli\u003eAggressive, pressure-sensitive latex bond for permanent (glue-down) installations\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eInstallation Instructions\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eStep 1: Spread the adhesive onto the substrate using the correct trowel or applicator for the job (see the spread-rate table below). If using a 1\/4 inch (6.4 mm) nap roller, apply a uniform layer to both the substrate and the back of the flooring.\u003c\/li\u003e\n\u003cli\u003eStep 2: For smooth products, back-rolling the troweled adhesive with a 1\/4 inch nap roller may be needed to prevent the trowel ridges from telegraphing through.\u003c\/li\u003e\n\u003cli\u003eStep 3: Allow enough open time for the adhesive to flash off before placing the flooring.\u003c\/li\u003e\n\u003cli\u003eStep 4: When the adhesive has flashed properly, the trowel valleys will be clear. If a nap roller was used, let it flash until it is almost clear.\u003c\/li\u003e\n\u003cli\u003eStep 5: Protect the exposed adhesive from dust and debris, which inhibit proper bond and reduce tack.\u003c\/li\u003e\n\u003cli\u003eStep 6: Lay the flooring into the adhesive and roll in both directions with a minimum 100 lb (45.4 kg) three-section roller.\u003c\/li\u003e\n\u003cli\u003eStep 7: Allow no foot traffic for 24 hours after installation, and allow 72 hours to fully cure before placing heavy furnishings or allowing heavy traffic.\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eSpread Rate\u003c\/h3\u003e\n\u003cp\u003eCoverage depends on the applicator used. Real spread rate varies with temperature, humidity, and substrate porosity.\u003c\/p\u003e\n\u003ctable\u003e\n\u003cthead\u003e\n\u003ctr\u003e\n\u003cth\u003eApplicator\u003c\/th\u003e\n\u003cth\u003eRecommended Use\u003c\/th\u003e\n\u003cth\u003eCoverage per Gallon\u003c\/th\u003e\n\u003c\/tr\u003e\n\u003c\/thead\u003e\n\u003ctbody\u003e\n\u003ctr\u003e\n\u003ctd\u003eU-notch trowel, 1\/16 x 1\/32 x 1\/32 inch\u003c\/td\u003e\n\u003ctd\u003eGeneral installation\u003c\/td\u003e\n\u003ctd\u003e200 to 250 sq ft\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eSquare-notch trowel, 1\/16 x 1\/16 x 1\/16 inch\u003c\/td\u003e\n\u003ctd\u003eFitness flooring\u003c\/td\u003e\n\u003ctd\u003e100 to 120 sq ft\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003e1\/4 inch (6.4 mm) nap roller\u003c\/td\u003e\n\u003ctd\u003eReduced-porosity substrate (applied to both surfaces)\u003c\/td\u003e\n\u003ctd\u003e60 to 70 sq ft\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003c\/tbody\u003e\n\u003c\/table\u003e\n\u003cp\u003eOpen time: 30 to 60 minutes. Working time: up to 2 hours.\u003c\/p\u003e\n\n\u003ch3\u003eSpecifications\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eColor: off-white\u003c\/li\u003e\n\u003cli\u003eSolids: 55%\u003c\/li\u003e\n\u003cli\u003eVOC: less than 20 g\/L\u003c\/li\u003e\n\u003cli\u003eWeight: 8.5 lbs per gallon\u003c\/li\u003e\n\u003cli\u003eShelf life: 2 years, stored unopened at 73 F\u003c\/li\u003e\n\u003cli\u003eStorage: 65 to 85 F, kept dry and out of direct sunlight in a well-ventilated area\u003c\/li\u003e\n\u003cli\u003eApplication conditions: 65 to 85 F\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eSubstrate and Concrete Requirements\u003c\/h3\u003e\n\u003cp\u003eFor permanent installations over concrete, the substrate must meet the following limits:\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eMaximum MVER of 8 lbs per 1,000 sq ft per 24 hours (ASTM F1869)\u003c\/li\u003e\n\u003cli\u003eMaximum 90% relative humidity (ASTM F2170)\u003c\/li\u003e\n\u003cli\u003eMaximum 10 pH (ASTM F710)\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eClean Up\u003c\/h3\u003e\n\u003cp\u003eClean fresh, wet adhesive off the flooring and tools with water. For cured adhesive, scrape first with a plastic putty knife, working carefully to avoid damaging the floor, then remove any remaining residue with ethyl alcohol on a clean, dry cloth.\u003c\/p\u003e\n\n\u003ch3\u003eLimitations\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eFor interior installations only.\u003c\/li\u003e\n\u003cli\u003eProtect from freezing.\u003c\/li\u003e\n\u003cli\u003eAvoid prolonged exposure to low temperatures, and do not exceed five freeze\/thaw cycles.\u003c\/li\u003e\n\u003cli\u003eIf frozen, do not stir until the product is completely thawed at room temperature.\u003c\/li\u003e\n\u003cli\u003eNot recommended for metal or fiberglass substrates.\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eAvailable Sizes\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003e1 gallon (3.8 L)\u003c\/li\u003e\n\u003cli\u003e4 gallon (15.1 L)\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch3\u003eSafety\u003c\/h3\u003e\n\u003cp\u003eThis is a low-VOC adhesive (less than 20 g\/L), Green Label Plus Certified, and low odor. For full handling, first aid, and disposal guidance, refer to the Safety Data Sheet (SDS).\u003c\/p\u003e\n\n\u003ch3\u003eDocuments\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003e\u003ca href=\"https:\/\/cdn.shopify.com\/s\/files\/1\/0723\/4250\/3585\/files\/Dance-Floor-Adhesive-Technical-Data-Sheet.pdf?v=1782759642\" target=\"_blank\" rel=\"noopener\"\u003eTechnical Data Sheet (PDF)\u003c\/a\u003e\u003c\/li\u003e\n\u003cli\u003e\u003ca href=\"https:\/\/cdn.shopify.com\/s\/files\/1\/0723\/4250\/3585\/files\/Dance-Floor-Adhesive-Safety-Data-Sheet.pdf?v=1782759642\" target=\"_blank\" rel=\"noopener\"\u003eSafety Data Sheet (PDF)\u003c\/a\u003e\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Rosco","offers":[{"title":"1 Gallon","offer_id":46553023250593,"sku":"10035_12067_50491","price":239.99,"currency_code":"USD","in_stock":true},{"title":"4 Gallon","offer_id":46624444711073,"sku":"ADH-LATEX-4GAL","price":499.0,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0723\/4250\/3585\/files\/B779-FWEBP_3dbd3b90-a5b3-49a6-8b4b-39f123afb7a3.webp?v=1781723172","url":"https:\/\/danceflooringinc.com\/products\/dance-floor-adhesive-latex","provider":"DanceFlooringInc","version":"1.0","type":"link"}